The ledger board is attached to the roof with 90 degree heavy duty stanley brackets the brackets need to be bent so the new ledger board is plumb.
Awning ledger board.
Also you need to keep enough open space approximately 3 4 inches above the top of the mounting bracket and ledger board.
Make sure the nails go through the wall studs.
In order to install the ledger board you usually need to remove the house s siding.
Hammer a 1 by 4 by 8 ledger board on the exterior wall of the house using 16 penny nails.
Where to attach a patio roof ledger.
The ledger should be attached before the foundation is built for a deck patio roof posts and other structure.
Locate a position for a header or ledger board.
The roof top brackets wood ledger board and lag bolts are to be purchased locally by customer.
Five ledger board techniques explained and illustrated.
Note you will need a minimum of 3 of unobstructed room above the top of the mounting bracket and ledger board for the awning to fit properly this measurement increases to 4 with a.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
A ledger header board is the first step if you are attaching the patio roof to an existing structure.
Make it the full width of the porch or slightly wider depending on your porch design.
Minimum of 7 6 from the deck or patio to the top of the mounting bracket and ledger board.
Any one of these five ledger connection methods properly installed will give you a reliable long lasting deck that is secure.
This is a time consuming process and should be done while the house is being constructed to simplify the process and reduce costs.
The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters.
The brackets are then lag bolted to the roof and sealed watertight.
The awning should be at least 7 to 8 feet above the ground or the patio.
Find the wall studs or roof trusses that will have to support the ledger.
Locating and mounting the ledger is normally a fairly easy process.
So make a mark above 7 to 8 inches and keep a minimum gap of 2 inches at one of the ends.
Determine how high it must be to provide an adequate slope to the roof.
Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.