The surface itself just has to be strong enough to handle your weight along with tools and gear.
Attic walkway plywood.
The intent is to lay down the boards and the ends should attach to a ceiling rafter.
Ensure that the end of the first plywood sheet lands on a piece of 2x leaving enough room to position the.
We used leftover plywood scraps to build ours an attic walkway also needs enough support.
No matter what the spacing is on your ceiling joists 3 4 inch plywood should be used if you plan on walking on it.
The previous homeowner may have simply covered the joists with plywood to use the space for storage.
Once the boards are in place place more screws placed 16 inches 40 64 cm apart to hold the plywood to the subfloor frame.
An attic walkway doesn t have to be pretty or expensive.
We normally recommend that you place plywood over the top of the rafters creating a walkway to the a c and in that area only lay in one or two layers of unfaced fiberglass blanket on top of the plywood walkway and around the ac unit itself.
The plywood should be laying on top of the subfloor with no overhang.
A 4 foot long plywood strip will need at least 8 screws on it.
Once you re done laying down all of the plywood your attic floor is finished.
The first plank is placed at the entrance of the attic walkway on the first horizontal chord.
Apply construction adhesive on one side and place it on the horizontal chord.
Continue the process until the flooring is finished.
Installing attic flooring for light storage only if your attic joists won t bear the weight necessary to finish out a living space but the engineer cleared them to support floor decking for light.
If you plan to finish the floor in the attic and turn the room into a living space however you should always use 3 4 inch.
Attics with existing flooring alternatively your attic may already have some sort of floor but this doesn t necessarily mean you can build rooms.
Place the first plywood sheet on top of the 2x structure starting by the attic entrance.